Digi TX54 User Manual page 408

Virtual Private Networks (VPN)
19. Click to expand Remote endpoint.
a. For IP version, select either IPv4 or IPv6.
b. For Hostname list selection, select one of the following:
n
n
n
c. Click to expand Hostname.
i. Click  next to Add Hostname.
ii. For Hostname, type a hostname or IPv4 address. If your device is not configured to
initiate the IPsec connection (see IKE >
keyword any, which means that the hostname is dynamic or unknown.
iii. Click  again to add additional hostnames.
d. Click to expand ID.
i. Select the ID type:
TX54 User Guide
FQDN: The ID will be interpreted as FQDN (Fully Qualified Domain Name) and
n
sent as an ID_FQDN IKE identity.
For FQDN ID value, type the ID as an FQDN.
KeyID: The ID will be interpreted as a Key ID and sent as an ID_KEY_ID IKE
n
identity.
For KEYID ID value, type the key ID.
MAC address: The device's primary MAC address will be used as the ID and
n
sent as a ID_KEY_ID IKE identity.
Serial number: The device's serial number will be used as the ID and sent as a
n
ID_KEY_ID IKE identity.
Round robin: Attempts to connect to hostnames sequentially based on the list
order.
Random: Randomly selects an IPsec peer to connect to from the hostname list.
Priority ordered: Selects the first hostname in the list that is resolvable.
Auto: The ID will be automatically determined from the value of the tunnels
n
endpoints.
Raw: Enter an ID and have it passed unmodified to the underlying IPsec stack.
n
For Raw ID value, type the ID that will be passed.
Any: Any ID will be accepted.
n
IPv4: The ID will be interpreted as an IPv4 address and sent as an ID_IPV4_
n
ADDR IKE identity.
For IPv4 ID value, type an IPv4 formatted ID. This can be a fully-qualified
domain name or an IPv4 address.
IPv6: The ID will be interpreted as an IPv6 address and sent as an ID_IPV6_
n
ADDR IKE identity.
For IPv6 ID value, type an IPv6 formatted ID. This can be a fully-qualified
domain name or an IPv6 address.
RFC822/Email: The ID will be interpreted as an RFC822 (email address).
n
For RFC822 ID value, type the ID in internet email address format.
FQDN: The ID will be interpreted as FQDN (Fully Qualified Domain Name) and
n
sent as an ID_FQDN IKE identity.
Initiate connection), you can also use the
IPsec
408