Digi TX54 User Manual page 887

System administration
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. To set the ignition power on delay:
(config)> system power ignition on_delay value
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the ignition power on delay to ten minutes, enter either 10m or 600s:
(config)> system power ignition on_delay 600s
(config)>
The default is 0s, meaning that there is no power on delay.
4. To set the ignition power off delay:
(config)> system power ignition off_delay value
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the ignition power off delay to ten minutes, enter either 10m or 600s:
(config)> system power ignition off_delay 600s
(config)>
The default is 0s, meaning that there is no power off delay.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
Power ignition sensor
887