Digi TX54 User Manual page 303

Hotspot
5. By default, For Device, select the appropriate Ethernet port.
By default, the ETH1 device is configured as the device for the WAN1 interface, and ETH2,
ETH3, and ETH4 are configured as devices in the LAN1 bridge, which is used by the LAN1
interface. As a result, when you add an Ethernet port to the hotspot, you may need to
reconfigure the Ethernet port configuration for other interfaces. For example, to remove the
ETH4 port from the LAN1 bridge:
a. Click Network > Bridges > LAN1 > Devices.
b. Click the ... menu icon next to the Ethernet: ETH4 device entry and select Delete.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Display a list of available devices by using the tab autocomplete feature:
(config)> add network bridge hotspot_bridge device end /network/<tab>
/network/device/eth1
/network/device/eth3
/network/device/loopback
/network/bridge/lan1
/network/wifi/ap/digi_ap2
TX54 User Guide
/network/device/eth2
/network/device/eth4
/network/bridge/hotspot_bridge
/network/wifi/ap/digi_ap1
/network/wifi/ap/digi_hotspot_ap1
Hotspot configuration
303