Digi TX54 User Manual page 312

Hotspot
This will be the SSID used by clients to connect to the hotspot. If you are creating multiple
access points, each access point must have the same SSID. Up to 32 characters are
allowed.
d. Set the encryption to open:
(config network wifi ap new_hotspot_AP1)> encryption type none
(config network wifi ap new_hotspot_AP1)>
Hotspot access points must use open (unencrypted) communication. See
for more information.
e. Type ... to return to the config prompt:
(config network wifi ap new_hotspot_AP1)> ...
(config)>
f. Add additional access points by following the above instructions.
4. (Optional) Create a new bridge and interface for the hotspot.
Note Hotspot bridges must also be part of an interface with a configured IP address.
a. Create a bridge:
(config)> add network bridge new_hotspot_bridge
(config network bridge new_hotspot_bridge)>
b. Add devices to the bridge:
i. Determine available devices:
(config network bridge new_hotspot_bridge)> .. .. interface lan1
device ?
Device: The network device used by this network interface.
Format:
Default value: /network/bridge/lan1
Current value: /network/bridge/lan1
(config network bridge new_hotspot_bridge)>
TX54 User Guide
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/wireless/ap/digi_ap1
/network/wireless/ap/digi_ap2
/network/wireless/ap/digi_hotspot_ap1
/network/wireless/ap/digi_hotspot_ap2
Hotspot configuration
Hotspot security
312