Digi TX54 User Manual page 590

Services
b. Use the index number to enable or disable the module:
n
n
Alternatively, you can use the index number to delete the DNSS location source:
(config)> del service location 1
(config)>
4. (Optional) Set the device to use Untethered Dead Reckoning (UDR):
(config)> service location source 1 enable_udr true
(config)>
5. Automatic attenuation is enabled by default. To disable:
(config)> service location source 1 enable_attenuation false
(config)>
6. Set the minimum satellite signal level for navigation:
(config)> service location source 1 min_cno int
(config)>
Where int is an integer between 1 and 6. The default is 6.
7. Set the minimum number of satellites for navigation:
(config)> service location source 1 min_satellites int
(config)>
Where int is an integer between 1 and 12. The default is 3.
8. Set the maximum number of satellites for navigation:
(config)> service location source 1 max_satellites int
(config)>
Where int is an integer between 3 and 24. The default is 18.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
To enable the module:
(config)> service location source 1 enable true
(config)>
To disable the module:
(config)> service location source 1 enable false
(config)>
Location information
590