Digi TX54 User Manual page 124

Interfaces
d. The authentication server port number defaults to 1812. To set an alternate port number:
(config network interface my_wan)> 802_1x authentication port port
(config network interface my_wan)>
e. Set the frequency period for reauthorization:
(config network interface my_wan)> 802_1x authentication reauth_period
value
(config network interface my_wan)>
where value is an integer between 0 and 86400. The default is 3600.
f. (Optional) Configure 802.1x authentication auditing:
i. Enable authentication auditing on the TX54 device:
(config network interface my_wan)> 802_1x accounting enable true
(config network interface my_wan)>
ii. Set the IP address of the accounting server:
(config network interface my_wan)> 802_1x accounting ip IPv4_
address
(config network interface my_wan)>
iii. Set the password for the accounting server:
(config network interface my_wan)> 802_1x accounting password
password
(config network interface my_wan)>
iv. The accounting server port number defaults to 1813. To set an alternate port number:
(config network interface my_wan)> 802_1x accounting port port
(config network interface my_wan)>
9. (Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Add a MAC address to the denylist:
(config network interface my_wan)> add mac_denylist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
10. (Optional) Configure the MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
TX54 User Guide
Wide Area Networks (WANs)
124