Digi TX54 User Manual page 313

Hotspot
ii. Add the appropriate device. For example, to add the Digi AP (Wi-Fi) Wi-Fi access
point:
(config network bridge new_hotspot_bridge)> add device end
/network/wireless/ap/digi_ap1
(config)>
c. Type ... to return to the config prompt:
(config network bridge new_hotspot_bridge)> ...
(config)>
d. Create an interface for the bridge:
(config)> add network interface hotspot_bridge_interface
(config network interface hotspot_bridge_interface)>
e. Add the new bridge to the interface:
(config network interface hotspot_bridge_interface)> device
/network/bridge/new_hotspot_bridge
(config network interface hotspot_bridge_interface)>
f. Set an IP address for the interface.
Note This IP address is not the IP address of the hotspot. The hotspot IP address is
configured during hotspot configuration.
(config network interface hotspot_bridge_interface)> ipv4 address ip_
address/netmask
(config network interface hotspot_bridge_interface)>
g. Type ... to return to the config prompt:
(config network interface hotspot_bridge_interface)> ...
(config)>
5. Create a new hotspot:
(config)> add network hotspot new_hotspot
(config network hotspot new_hotspot)>
New hotspots are enabled by default.
To disable:
n
(config network hotspot new_hotspot)> enable false
(config network hotspot new_hotspot)>
To enable, it it has been disabled:
n
(config network hotspot new_hotspot)> enable true
(config network hotspot new_hotspot)>
6. Add devices to the bridge:
TX54 User Guide
Hotspot configuration
313