Digi TX54 User Manual page 80

Interfaces
Note If the reboot parameter is enabled at the same time as the restart parameter, the reboot
parameter takes precedence.
(Optional) Set the number of times that the Surelink test must fail before the device is
n
rebooted:
(config network interface my_wan ipv4 surelink)> reboot_attempts int
(config network interface my_wan ipv4 surelink>
where int is any number greater than 0. The default is 1.
7. Add a test target:
(config network interface my_wan)> add ipv4 surelink target end
(config network interface my_wan ipv4 surelink target 0)>
8. Set the test type:
(config network interface my_wan ipv4 surelink target 0)> test value
(config network interface my_wan ipv4 surelink target 0)>
where value is one of:
ping: Tests connectivity by sending an ICMP echo request to a specified hostname or IP
n
address.
l
l
dns: Tests connectivity by sending a DNS query to the specified DNS server.
n
l
dns_configured: Tests connectivity by sending a DNS query to the DNS servers
n
configured for this interface.
http: Tests connectivity by sending an HTTP or HTTPS GET request to the specified URL.
n
l
TX54 User Guide
Specify the hostname or IP address:
(config network interface my_wan ipv4 surelink target 0)> ping_
host host
(config network interface my_wan ipv4 surelink target 0)>
(Optional) Set the size, in bytes, of the ping packet:
(config network interface my_wan ipv4 surelink target 0)> ping_
size [num]
(config network interface my_wan ipv4 surelink target 0)>
Specify the DNS server. Allowed value is the IP address of the DNS server.
(config network interface my_wan ipv4 surelink target 0)> dns_
server ip_address
(config network interface my_wan ipv4 surelink target 0)>
Specify the url:
(config network interface my_wan ipv4 surelink target 0)> http_
url value
(config network interface my_wan ipv4 surelink target 0)>
Wide Area Networks (WANs)
80