Digi TX54 User Manual page 10

Connect data cables
Connect antennas
Mount the TX54 to a mounting surface
Connect power
Mount and ground chassis
TX54 electrical rating
TX54 power connector
Battery power management
Configuration and management
Review TX54 default settings
Local WebUI
Digi Remote Manager
Default interface configuration
Other default configuration settings
Change the default password for the admin user
Reset default SSIDs and pre-shared keys for the preconfigured Wi-Fi access points
Configuration methods
Using Digi Remote Manager
Access Digi Remote Manager
Using the web interface
Log out of the web interface
Use the local REST API to configure the TX54 device
Use the GET method to return device configuration information
Use the POST method to modify device configuration parameters and list arrays
Use the DELETE method to remove items from a list array
Using the command line
Access the command line interface
Log in to the command line interface
Exit the command line interface
Interfaces
Wide Area Networks (WANs)
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs)
Configure WAN/WWAN priority and default route metrics
WAN/WWAN failover
Configure SureLink active recovery to detect WAN/WWAN failures
Configure the device to reboot when a failure is detected
Disable SureLink
Example: Use a ping test for WAN failover from Ethernet to cellular
Using Ethernet devices in a WAN
Using cellular modems in a Wireless WAN (WWAN)
Configure a Wide Area Network (WAN)
Configure a Wireless Wide Area Network (WWAN)
Show WAN and WWAN status and statistics
Delete a WAN or WWAN
Default outbound WAN/WWAN ports
Local Area Networks (LANs)
About Local Area Networks (LANs)
Configure a LAN
Example: Configure two LANs
Show LAN status and statistics
TX54 User Guide
34
34
34
35
35
36
37
37
39
39
39
39
43
43
45
47
49
49
49
50
50
50
52
53
55
55
55
56
58
60
60
63
64
75
83
87
91
92
116
125
135
137
139
140
141
141
149
159
10