Digi TX54 User Manual page 603

Services
b. Set the talker ID:
The default setting is Default, which means that the talker ID provided by the source
will be used.
9. (Optional) Set the text to prepend to the forwarded message. Two variables can be included in
the prepended text:
%s: Includes the TX54 device's serial number in the prepended text.
n
%v: Includes the vehicle ID in the prepended text.
n
(config service location forward 0)> prepend __|%s|__|%v|__
(config service location forward 0)>
10. (Optional) Set the vehicle ID.
Allowed value is a four digit alphanumerical string (for example, 01A3 or 1234). If no vehicle ID
is configured, this setting defaults to 0000.
(config service location forward 0)> vehicle-id 1234
(config service location forward 0)>
11. (Optional) Provide a description of the remote host:
(config service location forward 0)> label "Remote host 1"
(config service location forward 0)>
12. (Optional) Specify types of messages that will be forwarded. Allowed values vary depending on
the message protocol type. By default, all message types are forwarded.
If the message protocol type is NMEA:
n
Allowed values are:
l
l
l
l
l
l
To remove a message type:
a. Use the show command to determine the index number of the message type to be
TX54 User Guide
GP
GQ
Default value: Default
Current value: Default
(config service location forward 0)>
(config service location forward 0)> talker_id value
(config service location forward 0)>
gga: Reports time, position, and fix related data.
gll: Reports position data: position fix, time of position fix, and status.
gsa: Reports GPS DOP and active satellites.
gsv: Reports the number of SVs in view, PRN, elevation, azimuth, and SNR.
rmc: Reports position, velocity, and time.
vtg: Reports direction and speed over ground.
deleted:
Location information
603