Services
Note
By default, the access control list for the NTP service is empty, which means that all
downstream hosts connected to the TX54 device can use the NTP service.
8. (Optional) Set the timezone for the location of your TX54 device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to
adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show status and statistics of the NTP server
You can display status and statistics for active NTP servers
WebUI
1. Log into the TX54 WebUI as a user with Admin access.
2. On the main menu, click Status.
3. Under Services, click NTP.
The NTP server status page is displayed.
Command line
TX54 User Guide
Network Time Protocol
646