Digi TX54 User Manual page 976

Hide thumbs Also See for TX54:

Table of Contents

7. Enable Preserve system logs to save the current session's system log after a reboot.

By default, the TX54 device erases system logs each time the device is powered off or

You should only enable Preserve system logs temporarily to debug issues. Once you are

finished debugging, immediately disable Preserve system logs to avoid unnecessary wear to

the flash memory.

8. Click Apply to save the configuration and apply the change.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. (Optional) To change the heartbeat interval from the default of 30 minutes, set a new value.

The heartbeat interval determines the amount of time to wait before sending a heartbeat

event if no other events have been sent.

(config)> system log heartbeat_interval value

where value is any number of weeks, days, hours, minutes, or seconds, and takes the format

number{w|d|h|m|s}.

For example, to set the heartbeat interval to ten minutes, enter either 10m or 600s:

(config)> system log heartbeat_interval 600s

To disable the heartbeat interval, set the value to 0s

4. Enable preserve system logs functionality to save the current session's system log after a

reboot. By default, the TX54 device erases system logs each time the device is powered off or

You should only enable Preserve system logs temporarily to debug issues. Once you are

finished debugging, immediately disable Preserve system logs to avoid unnecessary wear to

the flash memory.

TX54 User Guide

Configure options for the event and system logs