Digi TX54 User Manual page 168

Interfaces
n
The default is auto.
f. Set the IP address or host name of the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced nftp_
server ip_address
(config)>
g. Set the relative path and file name of the bootfile on the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced bootfile
filename
(config)>
8. See Configure DHCP options
9. See Map static IP addresses to hosts
10. Save the configuration and apply the change:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Map static IP addresses to hosts
You can configure the DHCP server to assign static IP addresses to specific hosts.
Required configuration items
IP address that will be mapped to the device.
n
MAC address of the device.
n
Additional configuration items
A label for this instance of the static lease.
n
To map static IP addresses:

WebUI
TX54 User Guide
custom: Allows you to identify the IP address of the server. For example:
(config)> network interface my_lan ipv4 dhcp_server advanced
primary_dns_custom ip_address
(config)>
for information about custom DHCP options.
for information about static leases.
Local Area Networks (LANs)
168