Table of Contents
Advertisement
Routing
(config network route policy 0)> dst mac MAC_address
(config network route policy 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Routing services
Your IX10 includes support for dynamic routing services and protocols. The following routing services
are supported:
Service or
protocol
RIP
RIPng
OSPFv2
OSPFv3
BGP
IS-IS
Configure routing services
Required configuration items
Enable routing services.
n
Enable and configure the types of routing services that will be used.
n
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
IX10 User Guide
Information
The IPv4 Routing Information Protocol (RIP) service supports RIPv2 (
RFC1058
and RIPv1 (
).
The IPv6 Routing Information Protocol (RIP) service supports RIPng (
The IPv4 Open Shortest Path First (OSPF) service supports OSPFv2 (
The IPv6 Open Shortest Path First (OSPF) service supports OSPFv3 (
The Border Gateway Protocol (BGP) service supports BGP-4 (
The IPv4 and IPv6 Intermediate System to Intermediate System (IS-IS) service.
Use Digi Remote Manager to view and manage your
IP routing
RFC2453
)
RFC2080
).
RFC2328
).
RFC2740
).
RFC1771
).
219
Advertisement
Table of Contents
