Table of Contents
Advertisement
Firewall
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Port forwarding.
4. For Add port forward, click .
The port forwarding rule configuration window is displayed.
Port forwarding rules are enabled by default. To disable, click to toggle off Enable.
5. (Optional) Type a Label that will be used to identify the rule.
6. For Interface, select the network interface for the rule.
Network connections will only be forwarded if their destination address matches the IP
address of the selected network interface.
7. For IP version, select either IPv4 or IPv6.
Network connections will only be forwarded if they match the selected IP version.
8. For Protocol, select the type of internet protocol.
Network connections will only be forwarded if they match the selected protocol.
TX54 User Guide
Port forwarding rules
798
Advertisement
Table of Contents
