Re-Enable Cryptography After It Has Been Disabled - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

System administration

1. Log into the TX54 command line as a user with Admin access.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. Disable encryption with the following command:

> system disable-cryptography

3. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Re-enable cryptography after it has been disabled.

To re-enable cryptography:

1. Configure your PC network to connect to the 192.168.210 subnet. For example, on a Windows

a. Select the Properties of the relevant network connection on the Windows PC.

b. Click the Internet Protocol Version 4 (TCP/IPv4) parameter.

c. Click Properties. The Internet Protocol Version 4 (TCP/IPv4) Properties dialog appears.

d. Configure with the following details:

TX54 User Guide

Disable device encryption