Digi TX54 User Manual page 145

Interfaces
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new LAN or edit an existing one:
To create a new LAN named my_lan:
n
(config)> add network interface my_lan
(config network interface my_lan)>
To edit an existing LAN named my_lan, change to the my_lan node in the configuration
n
schema:
(config)> network interface my_lan
(config network interface my_lan)>
4. Set the appropriate firewall zone:
(config network interface my_lan)> zone zone
(config network interface my_lan)>
See Firewall configuration
5. Select an Ethernet device, a Wi-Fi device, or a bridge. See
bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_lan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/wireless/ap/digi_ap1
/network/wireless/ap/digi_ap2
/network/wireless/ap/digi_hotspot_ap1
/network/wireless/ap/digi_hotspot_ap2
Current value:
(config network interface my_lan)> device
TX54 User Guide
for further information.
Local Area Networks (LANs)
Bridging for more information about
145