Digi TX54 User Manual page 263

Wi-Fi
7. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap1 isolate_client true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
8. Set the IP address or hostname of the RADIUS server:
(config)> network wifi ap digi_ap1 encryption host_wpa2 hostname
(config)>
9. Set the secret key as configured on the RADIUS server:
(config)> network wifi ap digi_ap1 encryption key_wpa2 secret_key
(config)>
10. (Optional) Set the RADIUS server's port. The default is 1812.
(config)> network wifi ap digi_ap1 encryption port_wpa2 port
(config)>
11. (Optional) Change the Wi-Fi radio for the access point (dual-Wi-Fi models only):
a. Show available radios:
(config)> network wifi radio ?
Additional Configuration
---------------------------------------------------------------------
----------
wifi1
wifi2
(config)>
b. Set the appropriate radio:
(config)> network wifi ap digi_ap1 radio wifi1
(config)>
12. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
(config)> network wifi ap digi_ap1 encryption group_rekey value
(config)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
TX54 User Guide
Configure a Wi-Fi access point with enterprise security
for information about how to prevent clients connected to different
Wi-Fi1 radio
Wi-Fi2 radio
263