Table of Contents
Advertisement
Wi-Fi
7. (Optional) Enable Isolate clients to prevent clients that are connected to this access point
from communicating with each other. See
prevent clients connected to different access points from communicating with each other.
8. For Encryption, select one of the following:
WPA Personal (PSK): All Wi-Fi clients must support WPA to be able to authenticate.
n
WPA/WPA2 Personal (PSK): Wi-Fi clients that support WPA and WPA2 are able to
n
authenticate.
WPA2 Personal (PSK): All Wi-Fi clients must support WPA2 to be able to authenticate.
n
WPA2-PSK/WPA3-SAE mixed mode: Wi-Fi clients that support WPA2 and WPA3 are able
n
to authenticate.
WPA3 Personal (SAE): All Wi-Fi clients must support WPA3 to be able to authenticate.
n
Note
this device will have WPA3 capabilities.
9. For Pre-shared key, enter the password that clients will use when connecting to the access
point.
10. (Optional) For Group rekey interval, type the amount of time to wait before changing the
group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
Allowed values are any number of days, hours, minutes, or seconds, and take the format
number{d|h|m|s}.
For example, to set Group rekey interval to ten minutes, enter 10m or 600s.
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
11. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
12. Click Apply to save the configuration and apply the change.
Command line
Configure a new Access point
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
Only select WPA3 Personal (SAE) if you know that all Wi-Fi clients connecting to
for more information.
Configure a Wi-Fi access point with personal security
Isolate Wi-Fi clients
for information about how to
Configure a LAN
and
251
Advertisement
Table of Contents
