Digi TX54 User Manual page 260

Wi-Fi
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
4. Set the Wi-Fi radio for the new access point:
a. Show available radios:
(config network wifi ap new_AP)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
wifi1
wifi2
Current value:
(config network wifi ap new_AP)>
b. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
5. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
6. Set the security for the access point to wpa2:
(config network wifi ap new_AP)> encryption type wpa2
(config network wifi ap new_AP)>
7. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap1 isolate_clients true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
TX54 User Guide
Configure a Wi-Fi access point with enterprise security
for information about how to prevent clients connected to different
260