Digi TX54 User Manual page 259

Wi-Fi
e. For RADIUS secret key, type the secret key as configured on the RADIUS server.
f. To add additional RADIUS servers, click 
10. (Optional) For Group rekey interval, type the amount of time to wait before changing the
group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
Allowed values are any number of days, hours, minutes, or seconds, and take the format
number{d|h|m|s}.
For example, to set Group rekey interval to ten minutes, enter 10m or 600s.
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
11. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
12. Click Apply to save the configuration and apply the change.

Command line
Configure a new Access point
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
Configure a Wi-Fi access point with enterprise security
for more information.
Configure a LAN and
259