Digi TX54 User Manual page 129

Interfaces
g. For Use DNS:
n
n
n
The default setting is When primary default route.
19. Optional IPv6 configuration items:
a. Click IPv6 to expand.
b. IPv6 support is Enabled by default. Click to disable.
c. Set the Metric.
See Configure WAN/WWAN priority and default route metrics
metrics.
d. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
e. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
f. Set the MTU.
g. For Use DNS:
n
n
n
The default setting is When primary default route.
1. See Configure SureLink active recovery to detect WAN/WWAN failures
configuring SureLink.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX54 User Guide
Always: DNS will always be used for this WWAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
When primary default route: Only use the DNS servers provided for this WWAN
when the WWAN is the primary route.
Never: Never use DNS servers for this WWAN.
Always: DNS will always be used for this WWAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
When primary default route: Only use the DNS servers provided for this WWAN
when the WWAN is the primary route.
Never: Never use DNS servers for this WWAN.
Wide Area Networks (WANs)
for further information about
for information about
129