Digi TX54 User Manual page 614

Hide thumbs Also See for TX54:

Table of Contents

6. Define actions to be taken when the device's location triggers a geofence event:

To define actions that will be taken when the device enters the geofence, or is inside

the geofence when it boots:

a. (Optional) Configure the device to preform the actions if the device is inside the

b. Set the number of

c. Add an action:

TX54 User Guide

(config service location geofence test_geofence coordinates

3)> latitude 44.925161

(config service location geofence test_geofence coordinates

3)> longitude -93.399200

(config service location geofence test_geofence coordinates

This defines a square-shaped polygon equivalent to the following:

geofence when it boots:

(config)> service location geofence test_geofence on_entry

update_intervals

(config)> service location geofence test_geofence on_entry num_

intervals int

For example, if the update interval is 1m (one minute) and the num_intervals is set

to 3, the actions will not be performed until the device has been inside the

geofence for three minutes.

i. Type ... to return to the root of the configuration:

(config service location geofence test_geofence coordinates

that must take place prior to performing the

Location information