Digi TX54 User Manual page 348

Routing
Additional configuration items
A label for the routing policy.
n
Whether packets that match this policy should be dropped when the gateway interface is
n
disconnected, rather than forwarded through other interfaces.
To configure a routing policy:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Routes > Policy-based routing.
4. Click the  to add a new route policy.
The new route policy page is displayed:
New route policies are enabled by default. To disable, click to toggle Enable to off.
5. (Optional) For Label, type a label that will be used to identify this route policy.
6. For Interface, select the interface on the TX54 device that will be used with this route policy.
7. (Optional) Enable Exclusive to configure the policy to drop packets that match the policy
when the gateway interface is disconnected, rather than forwarded through other interfaces.
8. For IP version, select Any, IPv4, or IPv6.
TX54 User Guide
IP routing
348