Serial port
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the mode:
(config)> serial port1 mode remoteaccess
(config)>
5. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
6. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate rate
(config)>
7. Set the number of data bits used by the device to which you want to connect:
(config)>path-paramdatabits bits
(config)>
8. Set the type of parity used by the device to which you want to connect:
(config)>path-paramparity parity
(config)>
TX54 User Guide
Configure Remote Access mode
202