Table of Contents
Advertisement
System administration
4. (Optional) ) Configure the device to look for any updated device firmware during the
maintenance window. If updated firmware is found, it will then be installed. The device will
look for updated firmware both on the local device and over the network, using either a WAN
or cellular connection.
(config)> system schedule maintenance device_fw_update value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
Note
If your device is managed by a Digi Remote Manager configuration, the configuration
manages the device's firmware version. You should not enable this option.
5. (Optional) Configure the device to look for any updated modem firmware during the
maintenance window. If updated firmware is found, it will then be installed. The device will
look for updated firmware both on the local device and over the network, using either a WAN
or cellular connection.
(config)> system schedule maintenance modem_fw_update value
(config)>
TX54 User Guide
The behavior of the start time varies depending on the setting of the duration
length, which is configured in the next step.
If the duration length is set to 0, all scheduled tasks will begin at the exact
l
time specified in the start time.
If the duration length is set to 24 hours, the start time is effectively
l
obsolete and the maintenance tasks will be scheduled to run at any time.
Setting the duration length to 24 hours can potentially overstress the
device and should be used with caution.
If the duration length is set to any value other than to 0 or 24 hours, the
l
maintenance tasks will run at a random time during the time allotted for
the duration window.
If the duration length is set to one or more hours, the minutes field in the
l
start time is ignored and the duration window will begin at the beginning
of the specified hour.
ii. Configure the duration length (the amount of time that the maintenance tasks
will be run). If 0 is used, all scheduled tasks will begin at the start time, defined
in the previous step.
(config system schedule maintenance trigger 0)> length num
(config system schedule maintenance trigger 0)>
where num is any whole number between 0 and 24.
iii. Configure the frequency that the maintenance tasks should be run:
(config system schedule maintenance trigger 0)> frequency
value
(config system schedule maintenance trigger 0)>
where value is either daily or weekly. Daily is the default.
Schedule system maintenance tasks
899
Advertisement
Table of Contents
