Digi TX54 User Manual page 943

Central management
(config)> cloud drm keep_alive 600s
(config)>
8. (Optional) Set the amount of time that the TX54 device should wait between sending keep-
alive messages to the Digi Remote Manager when using a cellular interface. Allowed values are
from 30 seconds to two hours. The default is 290 seconds.
(config)> cloud drm cellular_keep_alive value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the cellular keep-alive interval to ten minutes, enter either 10m or 600s:
(config)> cloud drm cellular_keep_alive 600s
(config)>
9. Set the number of allowed keep-alive misses. Allowed values are any integer between 2 and
64. The default is 3.
(config)> cloud drm keep_alive_misses integer
(config)>
10. The watchdog is used to monitor the connection to remote cloud services. If the connection is
down, you can configure the device to restart the connection, or to reboot. The watchdog is
enabled by default. To disable:
(config)> cloud drm watchdog false
(config)>
11. If watchdog is enabled:
a. (Optional) Set the amount of time to wait before restarting the connection to the remote
cloud services, once the connection is down.
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set restart_timeout to ten minutes, enter either 10m or 600s:
(config)> cloud drm restart_timeout 600s
(config)>
The minimum value is 30 minutes and the maximum is 48 hours. If not set, this option is
disabled. The default is 30 minutes.
b. (Optional) Set the amount of time to wait before rebooting the device, once the
connection to the remote cloud servicesis down. By default, this option is not set, which
means that the option is disabled.
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set reboot_timeout to ten minutes, enter either 10m or 600s:
TX54 User Guide
Configure Digi Remote Manager
943