Digi TX54 User Manual page 878

System administration
Configuration reset:
n
l
l
Full device reset:
n
l
l
3. After resetting the device:
a. Connect to the TX54 by using the serial port or by using an Ethernet cable to connect the
TX54 LAN1 port to your PC.
b. Log into the TX54:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you will be required the change
the SSIDs and pre-shared keys (passwords) for the preconfigured Wi-Fi access points
before you can save any configuration changes. See
keys for the preconfigured Wi-Fi access points
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device with the revert command
You can reset the device to the default configuration without removing scripts, keys, and logfiles by
using the revert command:
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
TX54 User Guide
Press and hold the RESET button for 10 seconds.
The device reboots automatically and resets to factory defaults. This does not
remove any automatically generated certificates and keys.
After the device reboots from the first button press, immediately press and hold the
RESET button for 10 seconds again.
The device reboots again and resets to factory defaults, as well as also removing
generated certificates and keys.
for further information.
Erase device configuration and reset to factory defaults
Reset default SSIDs and pre-shared
for instructions.
Change the default
878