Digi TX54 User Manual page 186

Interfaces
a. To delete a device from the bridge, click the down arrow () next to the field label and
select Delete.
b. To add a device, for Add device, click  and select the Device.
6. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when using multiple LANs on the same device, to prevent bridge loops and other
routing conflicts.
a. Click STP.
b. Click Enable.
c. For Forwarding delay, enter the number of seconds that the device will spend in each of
the listening and learning states before the bridge begins forwarding data. The default is 2
seconds.
7. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The LAN1 bridge is enabled by default.
To disable:
n
(config)> network bridge lan1 enable false
(config)>
To enable if it has been disabled:
n
(config)> network bridge lan1 enable true
(config)>
TX54 User Guide
Bridging
186