Table of Contents
Advertisement
Services
To add a message type:
a. Change to the filter_taip node:
b. Use the add command to add the message type. For example, to add the id
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
(config service location forward 0)> del filter_taip 2
(config service location forward 0)>
(config service location forward 0)> filter_taip
(config service location forward 0 filter_taip)>
message type:
(config service location forward 0 filter_taip)> add id end
(config service location forward 0 filter_taip)>
Location information
605
Advertisement
Table of Contents
