Interfaces
---------------------------------------------------------------------
----------
dhcp_hostname
enable
metric
mgmt
mtu
type
use_dns
weight
Additional Configuration
---------------------------------------------------------------------
----------
connection_monitor
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See
Configure WAN/WWAN priority and default route metrics
metrics.
8. (Optional) To configure 802.1x port based network access control:
Note
The TX54 can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the TX54 device:
(config network interface my_wan)> 802_1x authentication enable true
(config network interface my_wan)>
b. Set the IP address of the authentication server:
(config network interface my_wan)> 802_1x authentication ip IPv4_
address
(config network interface my_wan)>
c. Set the password for the authentication server:
(config network interface my_wan)> 802_1x authentication password
password
(config network interface my_wan)>
TX54 User Guide
false
DHCP Hostname
true
Enable
0
Metric
0
Management priority
1500
MTU
dhcpv6
Type
always
Use DNS
10
Weight
Active recovery
Wide Area Networks (WANs)
for further information about
123