Digi TX54 User Manual page 90

Interfaces
a. Click Network > Interface > WWAN1 > IPv4.
b. For Metric, type 2.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure SureLink on WAN1:
a. Set the interval to ten seconds:
(config)> network interface wan1 ipv4 surelink interval 10s
(config)>
b. Delete the existing test targets:
(config network interface wan1> del ipv4 surelink target 0
(config network interface wan1> del ipv4 surelink target 1
(config network interface wan1)>
c. Add a test target:
(config)> add network interface wan1 ipv4 surelink target end
(config network interface wan1 ipv4 surelink target 0)>
d. Set the probe type to ping:
(config network interface wan1 ipv4 surelink target 0)> test ping
(config network interface wan1 ipv4 surelink target 0)>
e. Set the packet size to 256 bytes:
TX54 User Guide
Wide Area Networks (WANs)
90