Digi TX54 User Manual page 108

Hide thumbs Also See for TX54:

Table of Contents

Manual/Automatic—The device will attempt to connect to the carrier identified in the

Network PLMN ID. If the carrier is not available, the device will fall back to using

automatic carrier selection.

5. If Manual or Manual/Automatic are selected for Carrier section mode, enter the Network

and determine their PLMN ID. See

6. Click Apply to save the configuration and apply the change.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Depending on the model of the TX54 device, there may be one WWAN, named either wwan or

wwan1, or there may be two WWANs, wwan1 and wwan2, which correspond to each cellular

modem. Use the appropriate WWAN name. For example, to configure the carrier selection

mode for wwan1:

(config)> network interface wwan1 modem operator_mode value

where value is one of:

TX54 User Guide

themodem scan

command at the Admin CLI to scan for available carriers

Scan for available cellular carriers

Wide Area Networks (WANs)

for details.