Debug An Ipsec Configuration - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

Virtual Private Networks (VPN)

1. Log into the TX54 WebUI as a user with Admin access.

2. On the menu, select Status > IPsec.

The IPsec page appears.

3. To view configuration details about an IPsec tunnel, click the  (configuration) icon in the

upper right of the tunnel's status pane.

Command line

1. Log into the TX54 command line as a user with Admin access.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. To display details about all configured IPsec tunnels, type the following at the prompt:

> show ipsec all

3. To display details about a specific tunnel:

> show ipsec tunnel ipsec1

4. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Debug an IPsec configuration

If you experience issues with an IPsec tunnel not being successfully negotiated with the remote end of

the tunnel, you can enable IPsec debug messages to be written to the system log. See

and event logs

for more information about viewing the system log.

TX54 User Guide

---------------

: 192.168.2.1