Table of Contents
Advertisement
System administration
If Check if Python Out-of-Service is set, the maintenance window will only start if the
n
Python Out-of-Service is set. See
information.
7. (Optional) Click to enable Device firmware update to instruct the system to look for any
updated device firmware during the maintenance window. If updated firmware is found, it will
then be installed.
Note
If your device is managed by a Digi Remote Manager configuration, the configuration
manages the device's firmware version. You should not enable this option.
8. (Optional) Click to enable Modem firmware update to instruct the system to look for any
updated modem firmware during the maintenance window. If updated firmware is found, it
will then be installed. Modem firmware update looks for updated firmware both on the local
device and over the network, using either a WAN or cellular connection.
9. (Optional) Click to enable Configuration check to allow for the configuration to be updated,
including by custom scripts, during the maintenance window.
10. (Optional) Configure automated checking for device firmware updates:
a. Click to expand Firmware update check.
b. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates.
c. Modem firmware update check is enabled by default. This enables to automated
checking for modem firmware updates.
d. For Frequency, select how often automated checking for device and modem firmware
should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.
11. Click Apply to save the configuration and apply the change.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure a system maintenance trigger:
a. Add a trigger:
(config)> add system schedule maintenance trigger end
(config)>
TX54 User Guide
Schedule system maintenance tasks
Use Python to set the maintenance window
for further
897
Advertisement
Table of Contents
