Add An Ethernet Port To The Default Hotspot - Digi TX54 User Manual

Hotspot
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Add an Ethernet port to the default hotspot

Required configuration items
Enable default hotspot configuration. See
n
instructions.
Ethernet port to be added to the hotspot.
n
To add an Ethernet port to the default hotspot:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Bridges > hotspot_bridge > Devices.
4. Click the  to add a new device.
TX54 User Guide
Enable hotspot using the default configuration
Hotspot configuration
for
302