Digi TX54 User Manual page 783

Hide thumbs Also See for TX54:

Table of Contents

User authentication

5. Enter a Password for the user.

6. Assign the user to the admin group:

a. Click Groups.

b. For Add Group, click .

c. For Group, select the admin group.

d. Verify that the admin group has full administrator rights:

i. Click Authentication > Groups.

ii. Click admin.

iii. Verify that the admin group has Admin access enabled. If not, click Admin access to

iv. Verify that Access level is set to Full access. If not, select Full access.

e. Verify that Local users is one of the configured authentication methods:

i. Click Authentication > Methods.

ii. Verify that Local users is one of the methods listed in the list. If not:

ii. For Method, select Local users.

7. Click Apply to save the configuration and apply the change.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Verify that the admin group has full administrator rights:

(config)> show auth group admin acl

If admin > enable is set to false:

(config)> auth group admin acl admin enable true

TX54 User Guide

i. For Add Method, click .

Example user configuration