Create A New Hotspot - Digi TX54 User Manual

Hotspot
3. Click Apply to save the configuration and apply the change.

Command line
1. Create a new routing policy. See
2. During configuration, set the source address type to zone:
(config network route policy 0)> src type zone
(config network route policy 0)>
3. Set the zone to hotspot:
(config network route policy 0)> src zone hotspot
(config network route policy 0)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Create a new hotspot

Required configuration items
A device or bridge for the hotstpot.
n
If a bridge is used, it must be included in an interface with an assigned IP address.
l
The authentication mode:
n
If Local shared password is selected for the authentication mode, include the password.
l
If RADIUS shared password or RADIUS users is selected for the authentication mode,
l
include RADIUS configuration information.
If HotspotSystem is selected for the authentication mode, include HotspotSystem
l
configuration information.
See Hotspot authentication modes
The login page source, either Local or Remote.
n
If Remote is selected, include the IP address of fully-qualified domain name of the remote
l
web server that serves the login page.
An IP address and subnet for the hotspot.
n
TX54 User Guide
Configure a routing policy
for more information about authentication modes.
Hotspot configuration
for instructions.
305