Configure A Multicast Route - Digi TX54 User Manual

Services
Show NTP information
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show ntp
> show ntp
NTP Status Status
-----------------
Status
Sync Status : Up
Remote
Offset
----------------
- ------
*ec2-52-2-40-158
+1.561
128.136.167.120
1.895
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a multicast route

Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
command at the system prompt:
: Up
Refid
Jitter
-------------
129.6.15.32
0.991
128.227.205.3
0.382
Configure a multicast route
ST T When Poll Reach
-- - ---- ---- -----
2 u 191 1024 377
3 u 153 1024 1
Delay
------ -----
33.570
43.583 -
647