Digi TX54 User Manual page 861

System administration
1. Download the TX54 operating system firmware from the Digi Support FTP site to your local
machine.
Note For TX54 devices, there are three platform variants:
TX54-Dual-Cellular
n
TX54-Dual-Wi-Fi
n
TX54-Single-Cellular
n
Download the correct firmware for your variant of the TX54 device.
2. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
3. Load the firmware image onto the device:
> scp host hostname-or-ip user username remote remote-path local local-
path to local
where:
hostname-or-ip is the hostname or ip address of the remote host.
n
username is the name of the user on the remote host.
n
remote-path is the path and filename of the file on the remote host that will be copied
n
to the TX54 device.
local-path is the location on the TX54 device where the copied file will be placed.
n
For example:
> scp host 192.168.4.1 user admin remote /home/admin/bin/TX54-Dual-
Cellular-22.2.9.85.bin local /etc/config/ to local
admin@192.168.4.1's password: adminpwd
TX54-Dual-Cellular-22.2.9.85.bin
>
4. Verify that the firmware file has been successfully uploaded to the device:
> ls /etc/config/scripts
-rw-r--r--
Cellular-22.2.9.85.bin
-rw-r--r--
...
>
5. Update the firmware by entering the
firmware file name:
> system firmware update file TX54-Dual-Cellular-22.2.9.85.bin
36632K
netflash: got "/etc/config/TX54-Dual-Cellular-22.2.9.85.bin",
length=37511229
netflash: authentication successful
netflash: programming FLASH device /dev/flash/image
TX54 User Guide
1 root root
1 root root
system firmware update
Update system firmware
37511229 May 16 20:10 TX54-Dual-
2580 May 16 16:44 accns.json
command, specifying the
100% 36MB 11.1MB/s
861