Digi TX54 User Manual page 921

Hide thumbs Also See for TX54:

Table of Contents

2. At the command line, type config to enter configuration mode:

3. Enable the Bluetooth scanner:

(config> monitoring bluetooth_scanner enable true

4. (Optional) Set the number of seconds between scans:

(config)> monitoring bluetooth_scanner update_interval value

where value is any number of weeks, days, hours, minutes, or seconds, and takes the format

number{w|d|h|m|s}.

For example, to set update_interval to ten minutes, enter either 10m or 600s:

(config)> monitoring bluetooth_scanner update_interval 600s

The minimum value is 5 seconds, and the default is 15 seconds.

5. Enable the device to open an SSH port that remote hosts can access:

(config> monitoring bluetooth_scanner ssh enable true

6. (Optional) Set the number of the port that the Bluetooth scanner will use. The default is 3102.

(config)> monitoring bluetooth_scanner ssh port port

7. Configure access control:

To limit access to specified IPv4 addresses and networks:

(config)> add monitoring bluetooth_scanner ssh acl address end value

Where value can be:

Repeat this step to list additional IP addresses or networks.

To limit access to specified IPv6 addresses and networks:

(config)> add monitoring bluetooth_scanner ssh acl address6 end

Where value can be:

TX54 User Guide

A single IP address or host name.

A network designation in CIDR notation, for example, 192.168.1.0/24.

any: No limit to IPv4 addresses that can access the SSH service.

Enable the Bluetooth scanner