Table of Contents
Advertisement
Wi-Fi
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi.
4. Click to expand the appropriate Wi-Fi radio. For single-Wi-Fi models, there is only one radio
listed.
5. For Frequency band, select 5 GHz.
6. Click to enable DFS Client Support.
Note
When DFS Client Support is enabled, any enabled access points that use this radio will
not be started and cannot be used as access points.
7. Click Apply to save the configuration and apply the change.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX54 User Guide
Configure the Wi-Fi radio to support DFS channels in client mode
237
Advertisement
Table of Contents
