Digi TX54 User Manual page 277

Wi-Fi
h. To add a channel, click Add Scan frequency and select the appropriate channel.
8. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new Wi-Fi client:
(config)> add network wifi client new_client
(config network wifi client new_client)>
New clients are enabled by default.
4. Set the Wi-Fi radio for the new client:
a. Show available radios:
(config network wifi client new_client)> .. .. radio ?
Additional Configuration
---------------------------------------------------------------------
----------
wifi1
wifi2
(config network wifi client new_client)>
TX54 User Guide
Configure a Wi-Fi client and add client networks
Wi-Fi1 radio
Wi-Fi2 radio
277