Show Dns Server - Digi TX54 User Manual

Services
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show DNS server

You can display status for DNS servers. This command is available only at the Admin CLI.

Command line
Show DNS information
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show dns
> show dns
Interface
---------
wan1
wan1
wan1
wan1
wan1
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
command at the system prompt:
Label Server
----- ------------------------
192.168.3.1
fd00:2704::1
fe80::227:4ff:fe2b:ae12
fe80::227:4ff:fe44:105b
fe80::240:ffff:fe80:23b0
Configure DNS
Domain
------
577