Digi TX54 User Manual page 829

Firewall
where value is the IP port number, a range of port numbers using the format IP_port-
IP_port, or any.
viii. Set the source address type:
(config network qos 2 policy 0 rule 0)> src type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
TX54 User Guide
any: Source traffic from any address will be matched.
n
See Firewall configuration
interface: Only traffic from the selected interface will be matched. Set the
n
interface:
i. Use the ? to determine available interfaces:
(config network qos 2 policy 0 rule 0)> src interface ?
Interface: Match the IP address with the specified
interface's network address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan1
/network/interface/wwan2
Current value:
(config network qos 2 policy 0 rule 0)> src interface
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> src interface
/network/interface/wan1
(config network qos 2 policy 0 rule 0)>
address: Only traffic from the IP address typed in IPv4 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
address6: Only traffic from the IP address typed in IPv6 address will be
n
matched. Set the address that will be matched:
Configure Quality of Service options
for more information about firewall zones.
829