Digi TX54 User Manual page 298

Hotspot
5. For Address, enter a new IP address and subnet mask.
6. (Optional) Change the default DHCP server configuration.
Note The hotspot DHCP server is automatically enabled and cannot be disabled.
a. Click to expand DHCP server.
b. For Lease time, type the amount of time that a client DHCP lease is valid. The default is 10
minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Lease time to ten minutes, enter 10m or 600s.
c. For Lease range start, type the lowest IP address in the range to assign to hotspot clients.
The value entered here represents the low order byte of the IP address, and is combined
with the subnet of the hotspot's static IP address. The default is 100.
d. For Lease range end, type the highest IP address in the range to assign to hotspot clients.
The value entered here represents the low order byte of the IP address, and when DHCP
addresses are assigned to client, this number is combined with the subnet of the hotspot's
static IP address. The default is 250.
7. Click Apply to save the configuration and apply the change.

Command line
TX54 User Guide
Hotspot configuration
298