Digi TX54 User Manual page 152

Interfaces
iii. For Device, select Ethernet: ETH3.
iv. (Dual-Wi-Fi models only) For Add device, click  again and select WiFi access point:
Digi AP (Wi-Fi2).
6. Click Apply to save the configuration and apply the change.

Command line
Note The example command and output in this procedure are based on a dual-Wifi configuration.
Commands and output will vary slightly if your TX54 device is a single-WiFi model.
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Display a list of devices currently configured for the LAN1 bridge:
(config)> show network bridge lan1 device
0 /network/device/eth2
1 /network/device/eth3
2 /network/device/eth4
3 /network/wireless/ap/digi_ap1
4 /network/wireless/ap/digi_ap2
(config)>
4. Remove devices from the LAN1 bridge that will be used by other interfaces in this
configuration.
a. If your device is a dual-WiFi model, remove the Digi AP (Wi-Fi2) access point
(/network/wireless/ap/digi_ap2) from the bridge, using its index number, 4, as determined
above with the show command:
(config)> del network bridge lan1 device 4
(config)>
TX54 User Guide
Local Area Networks (LANs)
152