Digi TX54 User Manual page 136

Interfaces
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
lan1
lan1
loopback
wan1
wan1
wwan1
wwan1
wwan2
wwan2
>
3. Additional information can be displayed by using the
> show network verbose
Interface
Weight
----------------
----
defaultip
defaultlinklocal
lan1
lan1
loopback
wan1
wan1
wwan1
wwan1
wwan2
wwan2
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about WAN1, enter
show network interface wan1:
> show network interface wan1
wan1 Interface Status
---------------------
Device
TX54 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 10.200.1.101/30
IPv6 down
IPv4 pending
IPv6 down
Proto Status Type
----- ------- ------
IPv4 up static
IPv4 up static
IPv4 up static
IPv6 up static
IPv4 up static
IPv4 up dhcp
IPv6 up dhcp
IPv4 up modem
IPv6 down modem
IPv4 pending modem
IPv6 up modem
: wan1
Wide Area Networks (WANs)
show network verbose command:
Zone Device
-------- --------
setup lan1
setup lan1
internal lan1
internal lan1
loopback loopback
external wan1
external wan1
external wwan1
external wwan1
external wwan1
external wwan1
Metric
------ --
10 10
0 10
5 10
5 10
0 10
1 10
1 10
3 10
3 10
3 10
3 10
136