Enable Service Discovery (Mdns) - Digi TX54 User Manual

Services
where value is either:
active-backup: Transmits data on only one of the bonded devices at a time. When the
n
active device fails, the next available device in the list is chosen. This mode provides for
fault tolerance.
round-robin: Alternates between bonded devices to provide load balancing as well as
n
fault tolerance.
5. Add Ethernet devices:
a. Use the ? to determine available devices:
(config network bond name)> ... network device ?
Additional Configuration
---------------------------------------------------------------------
-------
eth1
eth2
eth3
eth4
loopback
(config network bond name)>
b. Add a device:
(config network bond name)> add device /network/device/eth1
(config network bond name)>
c. Repeat to add additional devices.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable service discovery (mDNS)

Multicast DNS mDNS is a protocol that resolves host names in small networks that do not have a DNS
server. You can enable the TX54 device to use mDNS.

WebUI
TX54 User Guide
Enable service discovery (mDNS)
653