Digi TX54 User Manual page 942

Central management
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Digi Remote Manager support is enabled by default. To disable Digi Remote Manager support:
(config)> cloud enable false
(config)>
4. (Optional) Set the service:
(config)> cloud service value
(config)>
where value is either:
drm: Digi Remote Manager
n
aview: Digi aView
n
The default is Digi Remote Manager.
5. (Optional) Set the URL for the central management server. The default is the Digi Remote
Manager server, my.devicecloud.com.
(config)> cloud drm drm_url url
(config)>
6. (Optional) Set the amount of time that the TX54 device should wait before reattempting to
connect to the remote cloud services after being disconnected. The minimum value is ten
seconds. The default is 30 seconds.
(config)> cloud drm retry_interval value
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the retry interval to ten minutes, enter either 10m or 600s:
(config)> cloud drm retry_interval 600s
(config)>
7. (Optional) Set the amount of time that the TX54 device should wait between sending keep-
alive messages to the Digi Remote Manager when using a non-cellular interface. Allowed
values are from 30 seconds to two hours. The default is 60 seconds.
(config)> cloud drm keep_alive value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the keep-alive interval to ten minutes, enter either 10m or 600s:
TX54 User Guide
Configure Digi Remote Manager
942